AutoFoam Touch-Free Wall-Mounted 1100 ml Dispenser

Customer Reviews Average Customer Review: Not yet rated Write an online review and share your thoughts with others.

There are no reviews

Automatic foam dispensing is redefined by combining the highest capacity system of its size with world-class reliability and environmental savings! Patented Smart Sensor™ and Dry Cam Gear technology in AutoFoam deliver a concentrated dose of enriched foam to provide the most hand washes – up to 38% more than similar foam systems. Energy efficient technology ensures an industry-leading battery life of 120,000 doses or 3 years. Plus, boxless refills reduce packaging waste for maximum environmental savings. Aesthetically Superior Design Enhances Décor Contemporary, stylish dispenser design is available in a wide array of color combinations to enhance the image and coordinate with any washroom décor. Touch-free delivery of foam soap helps keep dispensers clean and inviting for customers.

Warranty: 3 years against defects in parts and workmanship



Installation: • Mounts to wall, mirror or tile with screws/anchors or double-sided tape • Position the dispenser a minimum of 12 ½ inches above the counter to prevent any interference with the sensor. Battery Installation 1. Use the dispenser cabinet key to open the front cover. Insert the key into the holes located at the top of the dispenser, twisting the key, and pulling the cover towards you. The cover is hinged at the bottom of the dispenser. 2. Remove the soap refill pouch holder by pulling it straight up. 3. Insert four C-cell alkaline batteries (not included) making sure to place batteries in the compartment in the proper orientation as shown by the diagram in the battery compartment. 4. Replace the soap refill pouch holder. 5. The dispenser will turn “on” automatically once batteries are installed.* You will hear a long beep signifying the unit is activated. * If the dispenser appears non-functional, remove batteries, wait 4 minutes and re-insert. Mounting Dispenser 1. The dispenser should be mounted 6-8 inches above the counter-top, sink or other surface. 2. Once the batteries have been installed, without a refill installed in dispenser, close dispenser cover. The setup sequence will be initiated. During this period, the sensor will automatically detect if the dispenser is too close to a surface below by sounding a beeping tone every half-second and the green indicator light will flash once each second. As you are positioning the dispenser, you can verify the proper mounting distance by moving the dispenser away from the surface below the sensor until the tone and the green indicator light cease. 3. The dispenser can be mounted to either a mirror or a tile surface using the double-sided tape provided (3a) or mounting the dispenser to the wall (3b). 3a. Use the alcohol wipe provided to thoroughly clean any surface that will have adhesive tape attached. Pull off the protective backing off the adhesive tape and mount the dispenser to the wall holding it in place for 10-15 seconds allowing the tape to adhere to the mounting surface. Remove the batteries from the dispenser. Let the dispenser set up for 24 hours before installing the batteries and refill. 3b. Using the template from the dispenser carton, drill holes into wall with a 1/4" or 6mm drill bit where dispenser is to be mounted. Remove template and align holes in backplate of dispenser with the pre-drilled holes. Screws and anchors have been provided to mount the dispenser to the wall. NOTE: Insure that proper mounting hardware is used for your particular wall composition. 4. If an object remains in the sensing range for more then 10 seconds, the green LED will flash and no soap will be dispensed after the initial dose. Remove object and unit will operate normally LED/Tone Indicators Tone switch: When switch is set to ON position there will be one beep. When switch is set to OFF position there will be two beeps. LED Indicators and Tone (IR sensor error indications): Refill After 2,600 doses a red LED flashes twice every 2 seconds along with two beeps every 8 seconds indicating the refill needs to be replaced. Be careful to not remove or dislodge the refill while modifying any settings, as the dosing program will reset. Batteries When the batteries are low a yellow LED flashes once every 2 seconds, along with one beep every 16 seconds. 4 C-cell batteries will last 120,000 hand washes or 3 years, whichever comes first. Object in Sensor Range (within 4 inches of sensing window) Refill in dispenser - If an object is in the sensor range more then 10 seconds then the green LED will flash once every second, one beep every 1/2 second. Remove object and unit will operate normally. No refill in dispenser – If an object is in the sensor range then the green LED blinks once every second and beeps every 1/2 second continuously as long as object remains in sensing range. AutoFoam™ Soap Dispenser Installation Instructions Dispenser Activation 1. To activate dispenser, place hand under bottom of dispenser. If a second dose is needed, remove hand, and then replace hand under dispenser (When an object comes within 4 inches of the sensing window the dispenser will activate). 2. The dispenser cover must be closed to activate. Refill Insertion 1. Open dispenser cover with a dispenser cabinet key. 2. Remove the refill pouch from the packaging box. Place the refill pouch with the nozzle pointing down into the pouch holder. Remove and discard the nozzle cap. 3. Snap the pouch fitment into the U-shaped bracket insuring the nozzle fits into actuator lever. The pouch fitment will snap into place once both brackets have snapped over the fitment. At the same time, make sure the nozzle fits into the slotted actuator lever. 4. The dispenser and dose program resets automatically each time a refill is installed. You will hear a long beep once the refill is properly installed. 5. Close dispenser cover.

SmartSensorTM patented technology detects user’s hand to automatically dispense a 0.4 ml dose of foam. • On/Off Tone Switch allows the user to turn off/on the tone for low battery/low soap indicator. The “on” position is recommmended for set up. • Red LED status light starts to blink when refill is low (at 100 doses). The light will flash 1 time every 2 seconds. It will also beep 2 times every 8 seconds to indicate the refill needs replacing, if the optional tone switch is “on.” • Yellow LED status light blinks when battery life is low. • Green LED blinks when object is in the sensor field. • Interference Tone – if an object is in the sensor field for more than 10 seconds an optional beep tone will sound. • Installation Set Up – Dispenser must be installed far enough above the counter (greater than 12.5") to prevent interference with the sensor. A Superior Handwash Experience TC Enriched Foam formulas are highly concentrated to provide a richer, denser foam quality that leaves hands feeling soft and smooth. TC Enriched Foam contains special skin conditioning agents that are soothing to the skin for refreshing hand cleansing. Convenient automatic dispensing ensures delivery of the right amount every time.Touch Free Dispensing Encourages Healthy Hand Washing Touch-free delivery eliminates cross contamination to help reduce the spread of germs. Foam encourages hand washing. Disposable refills with TC’s HygienicSeal™ keep soap fresh and clean providing a more hygienic system than bulk soap. A recent study revealed that 25% of bulk soap systems were contaminated with potentially harmful bacteria(1). Lower Cost-In-Use More hand washes per refill reduce labor and soap costs. Reliable, controlled dispensing of concentrated soaps eliminates over use and costly waste – the number one problem with other soap systems. Large capacity refill delivers 0.4ml per dose for up to 2,750 hand washes, allowing fewer change outs. AutoFoam dispenses 5x more handwashes than traditional bag-in-box soaps and up to 38% more vs. other foam systems. World Class Reliability A new pump with every refill eliminates mess, clogs and leaks. This user-friendly system provides both visual and audio cues to indicate low soap level and low battery life for worry free maintenance. Energy efficient cam-gear technology provides industry-leading battery life – up to 120,000 dispenses or 3 years. Durable dispensers are impact resistant and key locked to protect the batteries and refill, helping to deter vandalism. Environmentally Superior System Boxless refills and controlled dispensing reduce packaging waste by up to 80% over traditional bag-inbox refills. Controlled dispensing eliminates over use and waste, so there are fewer chemicals in the waste stream. A specially formulated foam soap that is Green Seal Certified is available.

Enriched Foam Lotion Soap with Moisturizers Specially formulated with extra mild cleansing ingredients for frequent hand washing. Enriched with moisturizers to help soothe and soften the skin. Green Seal Certified. Enriched Foam Antibacterial Soap (E2 Rated) Effective formulation contains 0.5% Triclosan for 99.9% germ kill against potentially harmful bacteria, yet is mild enough for frequent use. Contains special moisturizers to help soothe and soften the skin. NSF Registered E2 for use in food preparation areas. Enriched Foam Alcohol-Free Hand Sanitizer Patented, non-flammable foam formula contains 0.1% Benzalkonium Chloride to sanitize hands without water. This unique non-drying sanitizer contains no alcohol and kills 99.99% of harmful germs, such as MRSA, in 15 seconds. Unlike messy gels, it dries quicky and leaves no sticky residue on hands. Enriched with moisturizers to keep skin soft and smooth. E3 registered for use in food handling areas.