Bobrick 1-1/4" Diameter Stainless Steel Swing Up Grab Bars, Exposed Mounting, Satin Finish

Customer Reviews Average Customer Review: Not yet rated Write an online review and share your thoughts with others.

There are no reviews

Satin-finish 18-gauge type 304 stainless steel tubing 1-1/4" (32mm) diameter.
Flange has exposed mounting screw holes.
Grab bar supports loads in excess of 250 pounds (113-kg) when properly installed.
Meets ICC/ANSI A117.1-2003 Accessibility Standards in U.S.A.
Mandrel bending process ensures uniform bar diameter around curves.
All joints and supports are contour cut and welded.
Concealed anchors and fasteners available as an optional accessory.
Peened nonslip gripping surface available.

Opperations: Swing-up grab bar is manually raised for approach or departure and lowered to horizontal position for support; once grab bar
is raised to the full upright (vertical) position, counterweighted design prevents grab bar from falling back down to the full
horizontal position. Meets ICC/ANSI A117.1-2003 Accessibility Standards in U. S. A.

Installation: Provide concealed anchor device or backing as specified or required in accordance with local building codes before wall is
finished. Fasten grab bar to anchor device or backing. Concealed anchor devices and mounted screws are not included with
Bobrick grab bars and must be specified as an optional accessory.

Diameter of grab bars should be 1-1/4" to 1-1/2" (32-38mm) with 1-1/2" (38mm) clearance from the wall, and should not rotate in their fittings. Required mounting height is universally 33" to 36" (840-915mm) from the centerline of the grab bar to the finish floor. Structural strength of all grab bars and their mounting devices should withstand more than 250 pounds of force (1112 N). For all barrier-free toilet compartments, individual toilet rooms and guest bathrooms, it is recommended that a 36" (915mm) min. horizontal grab bar be installed on the back wall over the toilet and a 42" (1065mm) min. horizontal grab bar be installed on the side wall or partition nearest the toilet. This can also be accomplished with a single horizontal two-wall grab bar.

Grab bar shall be type-304 stainless steel with satin finish. Grab bar shall have 18-gauge (1.2mm) wall thickness and 1-1/4"
(32mm) outside diameter. Backplate shall be 3/16" (5mm) thick stainless steel, equipped with screw holes for attachment to
wall. Swing-up grab bar shall be manually raised for approach or departure and lowered to horizontal position for support;
counterweighted design shall prevent grab bar from falling back down to the full horizontal position once grab bar is raised
to the full upright (vertical) position. Grab bar shall comply with ICC/ANSI A117.1-2003 Accessibility Standards in U. S. A..
Manufacturer's service and parts manual shall be provided to the building owner/manager upon request.