Stainless Steel Channel Frame Mirror with Shelf

Similar to 0620, but with 18 gauge stainless steel shelf with satin finish and all edges returned and hemmed for maximum rigidity and safety. Shelf is welded to face frame and is 5" (127 mm) wide. See chart for standard sizes.

Installation: Install “H” wall brackets level and plumb per diagram location using ONLY No 10 Pan Head screws (by others). Hang mirror on brackets and tighten locking screw at bottom (Note: this screw should be started prior to hanging frame). For compliance with ADA Accessibility Guidelines, bottom edge of reflecting surface should be no higher than 40" (1016mm) above finished floor(AFF).

MATERIALS Frame: Stainless steel alloy 18-8, type 304, 20 gauge (.036 in. <.91mm> thick) stainless steel. Roll-formed one piece construction. Exposed surfaces shall have No 4 satin finish. Edges and corners are burr free. Shelf: Stainless steel alloy 18-8, type 304, 18 gauge (.048 in. <1.2mm> thick) stainless steel. Unitized all welded construction. Exposed surfaces shall have No 4 satin finish. Edges and corners are burr free. Glass: Standard glazing is No 1 quality, 1/4"inch (6mm) thick plate/float, silver coated and hermetically sealed with a uniform copper plating, and warranted against silver spoilage for 15 years. Mirrors meet Federal Spec. DD-M-411C, ASTM -C- 1036-91. Filler: Expanded polyethylene microcell foam sheet material, abrasion resistant and shock absorbing, water resistant, 1/8′′ inch (3.2m) total layer thickness.

Channel Frame Mirror with Shelf shall have frame fabricated of alloy 18-8 stainless steel, type 304, 20 gauge with mitered corners. Shelf shall be 18 gauge, same grade. Mirror glazing shall be _____ (insert glazing option) and shall be warranted for 15 years against silver spoilage. All edges of mirror shall be protected by friction and chafe absorbing fillers. Back of mirror shall be protected by full size shock-absorbing water-resistant filler and full size one piece 20 gauge corrosion protected steel. Top and bottom wall mounting brackets shall be spot welded into an “H” for easy installation. Mirror shall be secured to lower bracket with a locking screw. Finish of unit shall be protected from marring by easily removed self adhesive polyvinyl (PVC) film.