Channel Frame Mirror

Customer Reviews Average Customer Review: Not yet rated Write an online review and share your thoughts with others.

There are no reviews

1⁄2" x 1⁄2" x 1⁄2" (13 x13 x13 mm) 20 gauge type 304 satin finish stainless steel channel is a one piece roll formed member that encases mirror and backing revealing a tight mitered corner. Mirror is installed on two wall brackets and held secure by theft resistant screw. See chart for standard sizes.

Installation: Install “H” wall brackets level and plumb per diagram location using ONLY No 10 Pan Head screws (by others). Hang mirror on brackets and tighten locking screw at bottom (note: this screw should be started prior to hanging mirror on wall brackets). For compliance with ADA Accessibility Guidelines, bottom edge of reflecting surface should be no higher than 40"(1016mm) above finished floor.

Frame: Alloy 18-8 stainless steel, type 304, 20 gauge (.036 in. <.91mm> thick) . Roll-formed one piece construction. Exposed surfaces shall have No 4 satin finish. Edges and corners are burr free. Glass: Standard glazing is No 1 quality, 1/4′′ inch (6.4mm) thick plate/float, silver coated and hermetically sealed with a uniform copper plating, and warranted against silver spoilage for 15 years. Mirrors meet Federal Spec DD-M-411C, ASTM C-1036-91. Filler: Expanded polyethylene microcell foam sheet material, abrasion resistant and shock absorbing, water resistant, 1/8′′ inch (3.2mm) total layer thickness.

Channel Frame Mirror shall have frame fabricated of alloy 18-8 stainless steel, type 304, 20 gauge with mitered corners. Mirror glazing shall be _____(insert glazing option) and shall be warranted for 15 years against silver spoilage. All edges of mirror shall be protected by friction and chafe absorbing fillers. Back of mirror shall be protected by full size shock-absorbing water-resistant filler and full size one piece 20 gauge corrosion protected steel. Top and bottom wall mounting brackets shall be spot welded into “H” hanger. Mirror shall be secured to lower bracket with a locking screw. Finish of unit shall be protected from marring by easily removed self adhesive polyvinyl (PVC) film.